Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
C
Useful information
NOTE:
• Be sure to wipe the stainless steel to prevent the
appearance of any unsightly scratches.
Surface of the control panel
The coating on the control panel can be cleaned with hot
soapy water. Make sure the cloth is clean and properly
wrung out before cleaning. Use a soft cloth to remove any
excess moisture left after cleaning.
IMPORTANT INFORMATION:
Use neutral detergents and avoid harsh chemicals,
strong household detergents or products containing
abrasives because they would damage the appearance
of the appliance, could remove any illustrations printed
on the control panel which would void the warranty.
Grease filters
Mesh grease filters can be cleaned by hand. Dip in water
containing a degreaser for 3 minutes, then brush them
with a soft brush. Do not press too hard to avoid damaging
them. (Let them dry in the open air and away from direct
sunlight.) The filters must not be washed along with dishes
and kitchen utensils. Rinse aid should not be used Refer to
the figure opposite to dismantle the grease filters.
18
EN
C
Useful information
Installation of grease filters
• To install the filters, please follow the following four steps.
- Tilt the filter in the slots at the rear of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter is locked in position.
- Repeat to install all the filters.
Charcoal filter (not supplied)
An activated charcoal filter may be used to neutralise odours.
Normally, the charcoal filter should be changed every three
to six months, depending on cooking habits. The installation
procedure of the activated charcoal filter is as follows:
Recycling version:
To transform the hood from the evacuation version to the
recycling version, ask your dealer for activated charcoal
filters.
Installing the activated charcoal filter (cassette)
• The aluminium filter must be removed to install the
activated charcoal filter.
19
EN
Advertenties
Inhoudsopgave
