Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
B
Using the appliance
3. After deciding on the height of the extractor hood, measure the position of the holes required
to suspend the hood as well as the inner duct mount. Drill 4 holes of 8: 2 for the inner duct
mount and 2 others to suspend the hood, while making sure it is properly levelled. The position
of the inner duct mount corresponds to the location of the duct. See figure 2
4. Screw two 4 x 30 mm screws to the wall using dowels to secure the hood, then use two 4 mm
x 40 mm screws to secure inner duct mount. See figure 2
5. Install the transformer as well as the expansion pipe on the outlet. Attach the extension pipe
to the transformer using the clamp. See figure 3
Reminder: the extension pipe is not supplied.
extension pipe
5. Install the outer duct mount using 2 ST4*8mm screws, ensuring that the inner duct remains
flexible. See figure 4
12
75 cm
65 cm
Figure 2
EN
B
Using the appliance
inner duct
outer duct mount
outer duct
6. Suspend the hood from the wall by adjusting its position and fix the extractor hood using 2
ST4*30 mm safety screws.
COMMENT :
The two safety vents are placed on the rear cover and have a 6 mm
diameter. See figure 5
7. Adjust the height of the inner duct relative to the position of the inner duct mount and fix it all
using 2 ST4*8 mm screws. See figure 6
13
Figure 4
Figure 5
Figure 6
EN
Advertenties
Inhoudsopgave
