Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
8. Make sure that the hotspot is equaly applied on the
surface for correct adjustment.
9. Tighten the adjustment lever and the 3 nuts when
the control cage is in correct position.
To stop the product
1. Push the abrasive control cable to close the abrasive
To operate the abrasive valve on
valve. Refer to
page 12 .
2. Push the OFF button to stop the blast motor.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
2124 - 002 - 14.05.2024
Maintenance
Before you do
3. Turn the ON/OFF switch to the OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust extractor. Refer to the operator's
manual of the dust extractor.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 6 .
Use personal protective
Personal protective
19
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
