Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
blast housing. Brush lists (B) are attached around the
magnetic seals.
The skid seal (C) moves on the surface.
A
B
To adjust the height of the magnetic
seals
1. Loosen the 2 adjustment screws at the rear wheels.
2. Loosen the 2 bolts (A) and turn the 2 adjustment
screws (B) to adjust the height.
3. Adjust the height until the magnetic seals are 8–10
mm from the surface.
2124 - 002 - 14.05.2024
C
A
B
4. Tighten the screws.
To adjust the height of the brush list
seals
The brush list seals wear when you operate the product.
It is necessary adjust the height of the brush list seals at
regular intervals.
1. Loosen the 2 screws that holds the brush list.
2. Adjust the height of the brush list until the brush list
is 1 mm above the surface.
3. Tighten the 2 screws.
Abrasive material
Speak to your Husqvarna dealer for the selection of
correct abrasive material for your surface operation.
Approved abrasive on page 27 .
Refer to
13
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
