Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
after the last movement has been detected, the
light will switch off (see Fig. I).
Installation
Note: Remove all packaging materials from
the product.
Make sure you will not be drilling into elec-
trical, gas or water lines inside the wall. Use
a power drill to drill the holes into the brick
wall. Always observe all safety instructions
for the power drill in the manual for the power
drill. Death or injury due to electric shock may
otherwise result.
When selecting the mounting location, pay
attention to the following:
1. The solar cell
requires direct sunlight when
6
possible. Ideally, the solar cell surface will be
directed to the south. The horizontal direction
of the solar cell is dependent on mounting
on a vertical wall.
2. Depending on the mounting height (ideally
at 2 m) the motion sensor
range of max. 5m with a detection angle of
100 ° horizontally and 90 ° vertically.
3. Be sure the motion sensor
by street lighting at night. This can influence
the effect.
Fix the mounting plate
rawlplugs
(Ø 6 mm) and the provided
1
screws
. Ensure that the arrow on the
3
marking of the mounting plate ( UP) is
showing vertically upward (Fig. A).
Note: The enclosed mounting material is
suitable for ordinary masonry construction.
Other wall substrates may require other fas-
tening materials. Seek specialist advice when
in doubt.
Set the switch
11
to start the operation of the product (Fig. G).
Attach the product to the mounting plate in
such a way that the hangers
mounting plate grip in the receivers
the back of the product. Slide the product
has a detection
7
is not illuminated
7
using the provided
2
to the position "I" or "II"
of the
4
on
5
GB/IE/NI
11
Advertenties
Hoofdstukken
Inhoudsopgave
