Download Inhoudsopgave Inhoud Print deze pagina

Appendix: Troubleshooting - Wartmann WM-2006 DH Gebruikshandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Appendix: troubleshooting

In general the Wartmann
dehydrator performs adequately. Should however a malfunction
occur, then please first try the troubleshooting recommendations mentioned below.
Symptom
Possible cause
The dehydrator does not work. The ON/OFF button is
The switch at the back is in the OFF position.
not flashing.
The power cord is damaged or not properly fitted in the
wall and/or dehydrator socket.
There is no voltage on the socket.
The dehydrator is broken.
The display shows time and temperature, but the fan is
Something is blocking the fan from running.
not running.
The remaining time is zero.
The fan is broken.
The display shows time and temperature, but the dehydrator
The temperature is set equal or below room temperature.
does not get warm
The heating element is broken.
There is a rattling noise coming out of the dehydrator.
Something is blocking the fan from running.
There is smoke coming out of the dehydrator.
Something is in contact with the heating element.
The dehydrator is broken.
Water or oil is dripping out of the dehydrator.
The dripping tray has not been placed.
The food is too wet or oily.
The dehydrator no longer works (properly).
There is a technical failure malfunction.
The dehydrator is broken.
16
Solution
Press the switch at the back to the ON position.
Check if the power cord is undamaged and then insert one side into the dehydrator
socket, then the other side into the wall socket.
Check with another electrical device that the socket has power; if so try the
dehydrator again.
Send the dehydrator in for repair.
Press the ON/OFF button to stop the programme, open the door and remove the
item blocking the fan.
Set the time to 30 minutes or more and try again.
Send the dehydrator in for repair.
Increase the temperature to above the room temperature.
Send the dehydrator in for repair.
Press the ON/OFF button to stop te programme, open the door and remove the
item blocking the fan.
Press the ON/OFF button to stop the programme, let it cool down and then remove
the item that is in contact with the heating element.
Stop using the dehydrator and send the dehydrator in for repair.
Place the dripping tray at the bottom of the dehydrator.
Dry the food and clean the dripping tray. Then try again.
Remove the plug from the socket, wait 10 seconds and reconnect the dehydrator.
Send the dehydrator in for repair.

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Inhoudsopgave