Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The control panel
ON/OFF button. Use this button to start and
stop the dehydrating program.
TIMER. Touch this button to set the required
dehydrating time.
TEMP. Touch this button to set the required
dehydrating temperature.
Decrease time/temperature. Hold this button to
decrease the required time or temperature.
Increase time/temperature. Hold this button to
increase the required time or temperature.
10
Preparing for first use
Unpack the dehydrator
Take the Wartmann
dehydrator out of the box
™
and remove all packaging materials. Position
the Wartmann
dehydrator near an electricity
™
connection, on a stable horizontal surface.
Make sure there is sufficient room for fresh air
circulation at the back and the emission of warm,
moist, air from the front.
Place the trays
The Wartmann
dehydrator comes with 6 stainless
™
steel trays and a stainless steel dripping tray. Open
the door and place the 6 trays by sliding them in
the guide rails on both sides. Place the dripping
tray at the bottom. Make sure that the end of the
trays are clear and that nothing is between the tray
D
and the ventilator mesh at the back.
Connect the power cable
The Wartmann
dehydrator comes with a
™
detachable power cord. Plug the connector of the
power cord in the socket on the back of the
Wartmann
™
dehydrator. Now plug the power plug
in the wall socket. Always use an earthed power
socket.
Switch the dehydrator on
The Wartmann
dehydrator has a main power
™
switch at the back. Press the power switch to switch
the dehydrator on. You may hear a short beep and
the ON/OFF button will start flashing.
The Wartmann
dehydrator is now ready for use.
™
11
Advertenties
Hoofdstukken
Inhoudsopgave
