Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Turn the knob that corresponds to the burner selected counterclockwise to the MAXIMUM position at the
etched star (large flame) and then press the knob down to activate the spark ignition. Once ignited, keep
pressing the knob for about 10 seconds to allow the flame to heat the thermocouple. If the burner does not
remain alight after releasing the knob repeat the above procedure,
Note: Dual burner is composed by two burner (inside and outside); each one operates under the relative gas valve
indipendently from the other one.
Note: It is recommended not to try to ignite the burner if the relative flame cap is not in the correct position
Tips for using burners correctly:
WARNING: During use of each gas burner(s) adjust the burner flame size properly so it does not
extend beyond the edge of the cooking utensil. This is an instruction based on safety considerations
- Use suitable pots for each burner (see Fig. 17 and Table B)
- When the liquid is boiling, turn down the knob to the MINIMUM position.
- Always use pots with a cover.
Table B
Burner
Medium
Large
Dual
Correct usage of pans:
- Dry the bottom of the pan before placing it on the hotplate.
- Use pots with a flat, thick bottom, except for wok cooking.
- When using the burners, ensure that the handles of the pans are correctly positioned. Keep children away
from the appliance.
- When cooking foods with oil and fat, which are very flammable, the user should not leave the appliance
unattended.
WARNING: If the power is cut off, the burners can be lit with matches.
The burners equipped with a safety thermocouple can only be lit when the knob is in the MAXIMUM position
(large flame etching).
Note: The use of a gas cooking appliance produces heat and humidity in the room where it is installed.
Therefore, proper ventilation in the room is needed and natural ventilation openings must remain
unobstructed and activating the mechanical exhaust fan/range hood. Intensive and continuous use of the
appliance may require additional ventilation, for example by opening a window, or increasing the power of
the mechanical exhaust fan/range hood, if installed.
Safety Precautions - Read before operating your cooktop
Your induction-cooking unit has been designed for residential use and food preparation, and all of the safety
parameters have been designed accordingly.
The unit incorporates numerous safety devices and controls, a few of which will be mentioned below:
- A number of sensors monitor the temperature of the internal components. If any of these sensors senses
that the component temperature is above the limit, the power output of the unit will automatically be reduced,
allowing the component to cool down. Once this is achieved, the unit will continue to operate normally at the
output level set initially by the operator..
-Each induction element is equipped with a sensor which is continuously monitoring the temperature of the
bottom of the pan to prevent the pan from overheating.
-Each induction element is equipped with a pan sensing device. This device will not allow the element to turn
on unless it senses an inductioncompatible pot or pan on the element covering enough surface area. If no
Recommended pan diameters (mm)
(140 – 260)
(180 – 260)
(220 – 260)
USING THE CERAMIC INDUCTIOB ELEMENTS
Advertenties
Inhoudsopgave
