Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
IE
Removing/inserting the re-
chargeable battery
1. To remove the rechargeable battery
(4) from the device, press the release
button (5) on the battery and pull the
battery out.
2. To insert the battery (4), push the battery
along the guide rail into the device. You
will hear it click into place.
Switching on and off
Switching the device on::
Briefly press the transparent On/Off
switch (1). The LED work light (6) now
lights up permanently.
Switching off the LED work light:
The device is switched on, the LED work
light lights up permanently. To switch off
the LED work light, now press and hold the
transparent On/off switch for several secon-
ds. The LED work light switches off, but the
device continues running.
To only switch off the LED work
light, make sure to press and hold
the On/off switch for several se-
conds. Pressing for too short of a
time switches off the entire device.
Switching the device off:
Briefly press the transparent On/Off
switch (1).
Place the cordless hot glue
gun on the inserted batte-
ry until the device is cooled
down completely. The hot
nozzle can cause damage
and/or burns.
8
The device has an automatic switch-
off when the device is not in use. It
switches off automatically after 30
minutes.
Operating temperature
indicator
After switching on the device, it heats up.
The transparent On/off switch (1) lights up:
On/off switch (1) lit up red
= device heating up
On/off switch (1) lit up green
= operating temperature reached
(approx. 140°C)
The device takes approx. 60 se-
conds to heat up before it reaches
the operating temperature.
Working with the device
Preparing the bonding surfaces
Do not use any flammable
solvents to clean the bonding
surfaces.
•
Clean the bonding surfaces! They must
be clean, dry and free of grease.
•
Roughen smooth surfaces before gluing.
•
Warm quick-cooling materials such as
steel up a bit before gluing. The glue
will stick better.
•
The ambient temperature and the mate-
rials to be glued must not be colder than
+ 5°C or warmer than + 50°C.
Gluing
•
Press the trigger (7) to regulate the glue
flow rate. If you are no longer able to
Advertenties
Hoofdstukken
Inhoudsopgave
