Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operating your radio – FM auto-tune
1. Straighten the antenna properly above the radio. Press
the Power On/Off button to switch on your radio.
2. Press and release the Source button until the FM (1 or 2)
band is selected.
3. To scan up in frequency, first rotate the Tuning control
knob in a clockwise direction and then press the
Tuning control knob. Your radio will scan in an upwards
direction (low frequency to high frequency) and stop
automatically when it finds a station of sufficient
strength. To scan down in frequency, first rotate the
Tuning control knob in a anti-clockwise direction and
then press the Tuning control knob. Your radio will scan
in a downwards direction and stop automatically when
it finds a station of sufficient strength.
After a few seconds the display will update. The display
will show the frequency of the signal found. If the signal
is strong enough and there is RDS data present then
the radio will display the station name.
4. When the waveband end is reached, your radio will
recommence tuning from the opposite waveband end.
5. Adjust the Volume control to the required setting.
11
6. To switch off your radio, press the Power On/Off button.
Note:
If you find the reception is poor, try repositioning the
antenna. It may be necessary to relocate your radio to a
position giving better reception and carry out a scan to
find stations.
Advertenties
Inhoudsopgave
