Advertenties
Beschikbare talen
Beschikbare talen
10. Insert / replace batteries
Before opening the rear cover,
switch off the power supply and
disconnect the test leads from
the input terminals and the
circuit.
1. When the battery voltage is ≤6 V ±0.2
V, the low battery symbol
displayed.
2. Turn the function dial to the "OFF"
position, and remove the test leads
from the input terminals.
3. Unscrew and remove the battery
cover to replace the battery.
11. Operation
Replace the battery if the low battery warning
inform–ation besides the warning signs marked on the DMM
terminals. The measured voltage or current must not exceed the values shown!
Test on known voltages to verify that the DMM is functioning correctly.
For accurate measurement results, make sure the probe tips and any areas of contact
are free from debris or residue.
a) Power ON
•
Turn ON: Set the function dial to the corresponding measurement function.
•
Turn OFF: Set the function dial to "OFF". Always turn the meter off when it is not in use.
42
will be
shows. Pay attention to the
beside the test lead
Advertenties
