Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Etude Plus
3. Press the spring pawl with a key or a screwdriver.
4. Hold the lower bar. Lower the side rail, until all three
bars are free of the bed end rail.
5. Repeat points 2 to 4 when dismounting the other end
of the side rail.
Operating
As a standard, the side rails can only be locked in top
position.
1. To lock / raise to upper position: Pull up the top side
rail bar, until the locking pin locks with an audible click
2. To release to lower position: Lift the top side rail bar
and press the two locking rings together and lower the
side rail.
Using a side rail height extender
Line and Britt V side rails can be supplemented by a height
extender. A side rail height extender increases the allowed
mattress thickness by 15 cm.
WARNING!
Risk of injury or death
A misapplied side rail height extender could fall
off. There's an increased risk for the user to fall
out of the bed.
– Make sure that the side rail height extender is
properly attached to the side rail. Refer to the
user manual of the side rail height extender.
– Make sure to use the correct height extender
for your side rail (the shape must match to
the shape of the side rail. A label on the
height extender determines to which side rail it
belongs. See image below.
12
Height extender for LINE
side rail:
4.5 Lifting pole
WARNING!
Risk of injury
The bed can tip if the handle is used, while the
lifting pole is turned away from the bed.
– The lifting pole always has to be positioned
with the handle hanging over the bed area.
– Do not exceed the maximum load of the lifting
pole; 80 kg.
4.5.1 Place the lifting pole
The lifting pole can be placed either on the left or the right
side of the head end of the bed.
1. Insert the lifting pole into the lifting pole tube and fix it
with the finger screw.
It's not required to tighten the finger screw, in case
you want the lifting pole to swing away to the side
of the bed.
4.5.2 Adjusting the handle height
The handle height should always be adjusted to the user's
need.
1.
A
1. Hold the cord out while sliding the plastic cord lock A
upwards or downwards until the handle reaches the
preferred height.
2. Lock the handle by pressing back the cord in the lock
A and pull the handle downwards.
IMPORTANT!
After adjusting the handle height:
– Check that the two cords above the cord lock
are parallel and inside the cord lock.
– Make sure the cord is properly locked by pulling
the handle hard.
Height extender for BRITT V
side rail:
2.
A
1551227-F
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
