Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CAUTION!
Risk of injury
User can fall, while entering or exiting the bed, if
brakes are not locked.
– Always lock the brakes before the user is
moving in or out of bed or when attending to
the user.
– At least one castor at the head end and one
castor in the foot end must be locked.
Castors might make marks on different types of
absorbing floor surfaces - such as untreated or
badly treated floors. To prevent marks, Invacare®
recommends to place a suitable kind of protection
between the castors and the floor.
4.3.1 Castor brake
Locking the brake
Step on the outer pedal A.
Unlocking the brake
Push up the release button B.
4.4 Operating side rails
WARNING!
Risk of entrapment or suffocation
There's a risk of entrapment or suffocation
between mattress support, side rail and bed end.
– Always ensure correct fitting of the side rails.
WARNING!
Risk of entrapment
There's a risk of entrapment or suffocation
between mattress support, side rail and bed end.
– When using removable side rails, always make
sure that the distance between the bed end
and the side rail's handle upper edge is less
than 6 cm in the head end and more than 32
cm in the foot end of the bed.
CAUTION!
If the side rail is not locked properly it can fall
down.
– Pull/push the top bar of the side rail to ensure
that the locking system is properly engaged.
CAUTION!
Risk of pinching fingers
– Pay attention to your fingers when assembling
or operating the side rail.
1551227-F
A
4.4.1 Operating Scala 2 side rail
1.
1. Up: Lift and pull the top bar B of the side rail towards
the end with the locking mechanism (release button) A
. Ensure, it is locked in place.
2. Down: Press the release button A and push the top bar
B of the side rail away from the locking mechanism.
4.4.2 Line and Britt V side rails
WARNING!
Risk of entrapment / suffocation
– To avoid the patient from entrapping or
accidentally falling from the mattress support, it
is essential that the gliding shoes are correctly
guided into the bed end rails. Adjust the side
rail bars by hand, to ensure they are mounted
correctly.
Mounting
CAUTION!
– Make sure that the straps between the rails are
not damaged or loose.
1. Mount one end at a time. Lift the upper side rail bar
(the release buttons must face up/outwards)
2. Press the locking pin at the end of the side rail with a
finger.
3. All three gliding shoes at the end of the bars are guided
into the bed end rail, until the lower bar has been
locked, thereby preventing the side rail from falling
down.
4. Repeat points 2 and 3 when mounting the other end
of the side rail.
Dismounting
1. Lower the side rail.
2. Dismount one end at a time. Lift the lower bar, so that
the spring pawl is visible.
Operating the bed
2.
11
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
