Inhoudsopgave
Advertenties
18
Pre-scrub mode
The TT Range have been designed to cope with a variety of floor types and different levels of soiling.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work, then scrub the area a second time
with the floor-tool lowered.
Floor-tool in use
19
Lowering the floor-tool
21
Note: The machine will still reverse with the floor-tool in the lowered position,
this could possibly damage the blades. Raise the floor-tool before reversing.
!
ALWAYS ENSURE THAT THE FLOOR IS
The clean-water / chemical mix is
dispersed via the 'THRU-FEED'
system.
The waste water is then retrieved by the
floor-tool.
Overlap the scrubbing path by 10cm to
ensure an even clean (Fig.19).
If streaking occurs, wipe the
floor-tool blades clean (Fig.20).
After preparing the floor (see previous
section), we are now ready to set the
controls to suit the cleaning conditions.
Before any settings can be applied,
ensure the brush deck is lowered.
Move the Floor-tool lever (see Fig.21),
to it's lower position (see Fig.22).
13
Pre-cleaning advice
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig.18).
Numatic part (629044) Wet Floor sign
(available if required)
PRE-SWEPT AND RELEVANT
SAFETY SIGNS ARE DISPLAYED.
20
Machine Set Up
22
!
Advertenties
Inhoudsopgave
