Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step 9:
Installation of cable 2 for butterfly (73) with double pulley holder 90°
(56).
1. Connect the both ends of cable 2 (73) with the appropriate holder at
butterfly arm left and right (10L+10R) as figure shows (leaded behind the
centre support (3)) by using screws M10x25 (59) and nuts M10 (18).
2. Insert one pulley (23) with 2 vavle slides (22) with cable 2 (73) into the
double pulley holder 90° (56). Put a washer (20) onto the screw M10x45
(90) and put the screw (90) through the double pulley holder 90° (56) with
pulley (23) and put a washer (20) and a nut (18) onto the screw end and
tighten it.
3. Now install the second pulley (23) with necessary parts without a cable
at double pulley holder 90° (56). The pulleys (23) should move easy. Then
put a screw cap (19) onto all screw heads (59+90) and nuts (18).
Step 10:
Installation of cable 1 for leg curler (72) with double pulley holder
(55).
1. Insert two pulleys (23) with 4 cable slides (22) into the double pulley
holder (55). Put a washer (20) onto the screws M10x45 (90) and put the
screw (90) through the double pulley holder (55) with pulleys (23). Place
a washer (20) and nut (18) onto the screw ends and tighten them. The
pulleys (23) should move easy. Then put a screw cap (19) onto all screw
heads (21) and nuts (18).
2. Pull cable 1 (72) with eye end through the leg curler (14) and around the
pulleys as figure shows and connect the end of cable 1 (72) at appropriate
holder on main base (1) by using chain (71) and carbine hooks (81).
3. Connect the curl bar (86) at cable 1 (72) by using the chain (71) and
carbine hooks (81). (When you use leg curler for exercising you should
take away the curl bar (86) with chain (71).
26
Advertenties
Inhoudsopgave
