Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step 2:
Installation of weight plates (37+40) and guide bars (5).
1. Put the guide bars (5) (ends with holes) into the appropriate position of
rear stabilizer (2) and secure them with screw M8x60 (29), curved was-
her 8//19 (30) and self locking nut M8 (49). Ensure that the screws are
put through the holes of guide bars so that they are blocked in bottom
position.
2. Slide the weight cover bracket (35) onto the guide bars (5).
3. Then put the rubber buffer (36) onto the guide bars (5).
4. Place the 7 weights (37) onto the guide bars (5) as you can see on step
drawing 2.
5. Put the weight disc bar (39) (with upper plastic ring and cylinder) (40)
into the weight plates (37) and put at least the smaller weight (37A) on.
6. Slide the second weight cover bracket (35) and the two fixing tubes (42)
onto the guide bars (5) and place the big washer (41) onto the centre of
upper weight pate (37A)
7. To adjust the loaded weights use the weight selector bar (38) and put it
into the weight disc bar (39) in desired position.
21
Advertenties
Inhoudsopgave
