Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.7.4 fault code display:
when the electronics detect faults in the system, these are
displayed in the form of fault codes on the display.
Error Codes Display
Fault code
30
Error Codes Controller
Fault code
13
14
15
16
Anti-rotation protection motor
17
19
21
Overcurrent / MOSFET error
22
23
24
25
Faults can arise once sporadically. Each time the device is
restarted, the fault code is deleted. If the fault should arise
again, we recommend that you make a note of the fault
code and contact your dealer.
6.7.5
Settings:
You can open the settings menu in order to carry out basic
settings by pressing the + and - button for 2 seconds.
NOTE:
• These settings can only be carried out when stationary.
1. Deleting the tripmeter:
press the "+" and "-" buttons at the same time and keep
them pressed for 2 seconds. The menu opens.
seconds in order to confirm the entry and leave the menu.
or
Press the "On/Off" button briefly to confirm and toggle to the
next menu point.
Empulse StreetJet
The fault code is always shown
in the bottom right corner of the
display.
Description
Communication error
Description
Overheating error
Voltage error
Motor output error
Processor error
error
Speed sensor error
Throttle control error
Motor phase error
Hall sensor error
Brake signal error
The display shows "tC-n",
pressing the "+" button you
can toggle between "tC-n"
(do not zero daily kilometres)
and "tC-y" (zero daily
kilometres). Select "tC-y" to
zero the odometer and press
the "On/Off" button for 2
2. Adjusting the brightness of the display backlight-
ing: "bL" ("backlight") will now be shown in the display
and the display backlight will be switched on.
or
Press the "On/Off" button briefly to confirm and toggle to
the next menu point.
Acceleration adjustment:
"SSP" will now be shown in the display.
In order to adjust the acceleration, you can select be-
tween four acceleration levels (SSP:1/ SSP:2/ SSP:3/
SSP:4) using the "+" and "-" buttons (1=high acceleration
/ 4=low acceleration). Press the "M" button for 2 seconds
to confirm the entry and leave the menu.
SSP:1 max acceleration
SSP:2 high acceleration
SSP:3 medium acceleration
SSP:4 low acceleration
To save the settings and return to home screen press M
for two seconds.
or
Press the "On/Off" button briefly to confirm and toggle to
the next menu point.
6.7.6
Changing the units:
"U" ("Unit") will now be shown in the display.
Using the "+" and "-" buttons you can toggle between
"U-1" (miles/mph) and "U-2" (kilometre/kph). Press the
"On/Off" button for 2 seconds in order to confirm the entry
and leave the menu.
20
In order to adjust the
brightness, you can select
between three brightness
levels (bL-1/ bL-2/ bL-3)
using the "+" and "-"
buttons. Press the "On/Off"
button for 2 seconds to
confirm the entry and
leave the menu.
Rev.C | English
Advertenties
Hoofdstukken
Inhoudsopgave
