Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MAINTENANCE
Replacing the oven lamp
Cleaning the gas hob
EN 24
Before replacing the oven lamp, switch off the appliance by
removing the plug from the socket or switching off the fuse in the
fuse box. Allow the appliance to cool down. Wear hand protection
when removing the lamp.
The appliance contains a light source of energy efficiency class G.
• Unscrew the glass cover (anticlockwise) and replace the oven lamp.
• Fit a new lamp with the same specifications (230 V, 15-25 Watt,
type E14, resistant to 300 °C).
• Screw the glass cover back on tightly.
The lamp in this household appliance is only suitable for illumination of
this appliance. The lamp is not suitable for household room illumination.
The lamp is consumable material and is not covered by the guarantee.
Your gas hob has been manufactured from high-grade, easy-to-
clean materials.
• Regular cleaning immediately after use prevents food spills from
becoming ingrained and causing stubborn stains that are difficult to
remove. Use a mild cleaning detergent to remove stains. Do not use
too much moisture, as there is a risk that it will penetrate into the
burner or vent holes.
• Clean the control knobs, burners and pan supports first and then
the drip tray. This prevents the drip tray from becoming dirty again
during cleaning.
• The ignition plugs should preferably be cleaned with a cloth. Do
this carefully. Otherwise the spark plug can become defective. The
spark plug will only operate correctly in a dry environment. If the
plug is very dirty, you can clean it with a tiny brush.
• Set the pan supports down vertically, without sliding them over
the drip tray.
• Assemble the burner parts using the guide ridges. Pay attention to
the notches for the ignition plug and thermocouple. Make sure the
burner parts are lying flat.
Advertenties
Hoofdstukken
Inhoudsopgave
