Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
IE
NI
Quick-connect adapter
(third-party device)
Procedure (Fig. D)
Quick-connect adapter (21) with safety
clip (20) for pressure washers made by
third-party manufacturers.
1. Insert the quick-connect adapter (21)
into the water connection (11).
You will hear it click into place.
2. Pull the safety clip (20) out of the
quick-connect adapter.
3. Connect a pressure washer via the
quick-connect adapter.
4. Secure the connection by inserting the
safety clip into the two holes of the
quick-connect adapter.
Using cleaning agents
• Use a neutral, biodegradable cleaning
agent.
• Always use the cleaning agent in ac-
cordance with the manufacturer's in-
structions.
Cleaning, maintenance
and storage
WARNING! Risk of injury due to un-
intentional start-up. Protect yourself when
performing maintenance or cleaning work.
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
• Always keep the product clean.
• Clean the device with a soft brush or a
slightly damp cloth.
• Do not use any cleaning agents or
solvents.
8
Maintenance
CAUTION! Replace a damaged high-
pressure hose.
Removing the high-pressure hose
(Fig. E)
1. If necessary, detach the flat spray
nozzle (1) by pressing, turning and
pulling it out (Bayonet locking device)
from the elbow connector.
2. Remove the safety clip (3).
3. Pull the elbow connector (2) off the ex-
tension arm (4).
4. Press and hold the release (19).
5. Pull the elbow connector (2) off the
high-pressure hose (25).
6. Pull the release lever (9) to the connec-
tion for the high-pressure hose (8).
7. Pull the high-pressure hose (25) off at
the connection for the high-pressure
hose.
8. Pull the high-pressure hose out through
the opening (7).
Installing the high-pressure hose
(Fig. E)
1. Slide the high-pressure hose (25) with
connection for the elbow connector
(24) first into the opening (7).
2. Push the high-pressure hose through
the main tube (5) and the extension
arms (4).
3. Fitting the elbow connector (2).
Make sure that the holes on the elbow
connector are aligned with the holes
on the extension arm.
4. Fix the elbow connector with the safety
clip (3).
5. Attach the flat spray nozzle (1) by in-
serting and turning it (Bayonet locking
device) on the elbow connector.
Advertenties
Hoofdstukken
Inhoudsopgave
