Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operating Instructions
Programming the remote control
Caution
• Risk of injury by electric shock.
• Must be installed by an authorised electrician!
• Only the back of the hand is protected by the device. No protection
against accidental contact!
• The programming button must be operated with an insulated tool.
• The switched current of the device must be observed at all times.
Setting the VC520 to programming mode
a) Set the VC520 to programming mode by switching on the power sup-
ply
Switch on the power supply.
The VC520 will remain in programming mode for 3 minutes.
b) Set the VC520 to programming mode using the programming button
Press and hold the programming button for 3 seconds.
The VC520 will remain in programming mode for 3 minutes.
Programming master transmitter
Press and hold the programming button for 3 seconds while in programming
mode.
The system will confi rm the programme setting with a 'nod', i.e. the shutter/
awning/blind moves a few centimetres in one direction and t hen reverses
the same distance.
This confi rmation is hereafter referred to as 'nodding'.
The programming process is now complete.
Note
If a transmitter has already been programmed in the receiver, press the
programming button and hold for 10 seconds.
22
Advertenties
Inhoudsopgave
