Overwriting The Master; Switching On/Off And Dimmer Function; Operating 2 Lighting Steps - Becker Centronic VarioControl VC220 Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic VarioControl VC220:

Inhoudsopgave

Advertenties

Beschikbare talen

Assembly and Operating Instructions

4) Overwriting the Master

1. Switch off the power supply to the VC220 and switch it on again after 10 sec-

onds.

The VC220 goes into programming mode for 3 minutes.

Note

To ensure that the new master transmitter is only programmed into the

desired VC220, you have to remove all the other receivers which are

connected to the same power supply from the programming mode.

To achieve this, carry out a dimming command with the transmitter of

these receivers after reconnecting the voltage supply.

2. Now press the programming button of the new master transmitter for 10 sec-

onds.

Confirmation occurs via optical feedback.

The new master transmitter has been programmed and the old mater transmit-

ter has been deleted.

5) Switching on/off and dimmer function

Use the Up/Down button and the Stop button on the transmitter to switch the

lighting system on and off respectively.

Press and hold the Up button (lighter) or the Down button (darker) on the trans-

mitter to dim the lighting system.

6) Operating 2 Lighting Steps

6a) Maximum brightness value

Press the UP button twice within one second.

The lighting system shines at the maximum brightness value.

6b) Mean brightness value

Press the DOWN button twice within one second.

The lighting system shines at the mean brightness value

Inhoudsopgave

Advertenties

Inhoudsopgave