Assembly; Programming The Remote Control; Programming The Master Transmitter; Programming Further Transmitters - Becker Centronic VarioControl VC220 Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic VarioControl VC220:

Inhoudsopgave

Advertenties

Beschikbare talen

Assembly and Operating Instructions

The VC220 can, for example, be assembled in or onto the head rail of a Venetian

blind.

Programming the remote control

1. Connect the VC220 to the power supply and the lighting system.

2. Now switch on the voltage supply.

3. The VC220 goes into programming mode for 3 minutes.

1) Programming the master transmitter

Press the programming button of the transmitter for 3 seconds while in pro-

gramming mode.

The lighting system confirms programming with an optical feedback.

Programming has now been completed.

Note

If a transmitter has already been programmed into the receiver, press

the programming button for 10 seconds.

2) Programming further transmitters

Note

In addition to the master transmitter it is possible to program up to 13

transmitters in the VC220.

1. Press the programming button of the master transmitter (programmed under

1)) for 3 seconds.

Confirmation occurs via optical feedback.

2. Now press the programming button of a new transmitter which is unknown to

the VC220 for 3 seconds. This activates the programming mode of the VC220

for a new transmitter for 3 minutes.

3. Now once again press the programming button of the transmitter which is to

be programmed for 3 seconds.

Confirmation occurs via optical feedback.

The new transmitter has been programmed.

Assembly

Inhoudsopgave

Advertenties

Inhoudsopgave