Programming Additional Transmitters; Deleting Transmitters; Deletingindividual Transmitters - Becker Centronic VarioControl VC220 Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic VarioControl VC220:

Inhoudsopgave

Advertenties

Beschikbare talen

Programming additional transmitters

In addition to the master transmitter, up to 12 further trans-

mitters can be programmed in the radio receiver.

Press the programmed master transmitter's programming button for 3

seconds.

▻ The receiver confirms.

Now press the programming button of a new transmitter which has not yet

been programmed in the radio receiver for 3 seconds. Doing so activates the

programming mode of the radio receiver for a new transmitter for 3 minutes.

▻ The receiver confirms.

Now re-press the programming button of the new transmitter you wish to pro-

gram for 3 seconds.

▻ The receiver confirms.

► The new transmitter has now been programmed.

The programmed master transmitter cannot be deleted. It

can only be overwritten.

Press the programming button on the master transmitter for 3 seconds.

▻ The receiver confirms.

Now press the programming button of the transmitter to be deleted for 3

seconds.

▻ The receiver confirms.

Then press the programming button of the transmitter to be deleted again for

10 seconds.

18 - en

Inhoudsopgave

Advertenties

Inhoudsopgave