Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
■
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket. The control
LED
lights up red to indicate that the appli-
ance is charging.
♦
The green LED
indicates that the charging
process is complete and the battery pack
ready.
♦
Push the battery pack
ance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Push the rotation direction switch
middle position (lock). Allow the battery pack
to click into the handle.
Removing the battery pack:
♦
Press the release button
battery pack.
Checking the battery charge level
♦
Press the ON/OFF switch
of the battery (see also main diagram). The
status/remaining charge will be shown on the
battery display LED
♦
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
│
GB │ IE │ NI
■
6
to the high-speed
(see Fig. A).
back into the appli-
into the
and remove the
to check the status
as follows:
Changing tools
Your cordless drill has a fully automatic spindle
lock
.
When the motor is stopped, the power train locks
so that the chuck
it
. Once you have attached the desired tool
and tightened it by turning the chuck
continue working. The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed).
Torque selection ring/drill setting
You can set the torque using the torque selection
ring
.
♦
Select a low level for small screws or soft
materials.
is
♦
Select a high level for large screws, hard
materials or removing screws.
♦
Select the drill setting for drilling work by
adjusting the torque selection ring to the
position .
2 speed gearbox
CAUTION!
►
Operate the speed selection switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear (speed selector switch
tion: 1)
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (speed selector switch
position: 2)
you can reach a speed of approx. 1300 rpm for
carrying out drilling work.
can be opened by turning
, you can
in posi-
PABS 16 A2
only
in
Advertenties
Hoofdstukken
Inhoudsopgave
