Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Electronic programmer*
functions
– function selection button
MENU
< - sensor "–"
> - sensor "+"
Setting the time
After connection to the mains or reconnec-
tion after a power cut the display shows flash
00 00
Touch and hold
touch < and >) until you will see
display and the dot below the symbol is
flashing,
Touch < or > within 7 seconds to set the
current time.
To store the new time setting, wait approxi-
mately 7 seconds after time has been set.
The dot below the
You can adjust the time later. To do this touch
< and >, simultaneously and adjust the cur-
rent time while the dot below the
is flashing.
Caution!
If the correct time is not set then proper opera-
tion of the oven is not possible.
*optional
(or simultaneously
MENU
on the
symbol will stop flashing.
symbol
Timer
The timer can be activated at any time, re-
gardless of the status of other functions. The
timer can be set for from 1 minute to up to 23
hours and 59 minutes.
To set the timer you should:
Press sensor
show flashing
00 00
set the timer using sensors > and <.
The time set is shown on the display and the
signal function
Press sensor
switch off the signal, the signal function will go
out and the display will show the current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
15
, then the display will
MENU
,
is on.
< or > in order to
MENU ,
Advertenties
Hoofdstukken
Inhoudsopgave
