Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PROBLEM
The alarm goes
off.
The side panels
are hot.
Abnormal noise
The temperature
cannot be set.
The lamp is
broken.
7. TAKING OUT OF SERVICE
Switching off and storage
•
If the appliance will not be used for several months, first switch it off and then pull the plug out of the socket.
•
Make sure the appliance is completely thawed.
•
Clean the inside thoroughly and wipe dry. To prevent the formation of odours and moulds, leave the door open:
block it.
•
Clean the door gasket groove with soap and water and wipe everything dry with a soft cloth.
•
Do not use a hard brush, steel brush, detergent, soap powder, alkaline detergent, benzene, gasoline, acids, hot
water or other corrosive or soluble substances to clean the appliance.
•
Store the cleaned appliance in a dry, ventilated place, away from a heat source. Make sure the appliance is on
a level surface and do not place heavy objects on top.
•
The appliance in storage must not be accessible to children playing.
POSSIBLE CAUSE
- The door is open.
- This is normal.
The heat exchanger components are on
the side of the appliance.Immediately
after installation, the sides become
hot, after the fridge reaches its internal
temperature, the temperature of the
side panels will decrease.
- The appliance is not stable/level.
- The appliance is making contact with
the wall or other objects.
- 'Super mode' is enabled.
- 'Super mode' is enabled.
- The control panel is locked.
- The lamp is broken.
SOLUTIONS
- Make sure the door is completely
closed and stays closed. Press the
'Alarm/Eco' button
- Readjust the appliance's adjusting
legs.
- Move the appliance slightly.
- This is normal. 'Super mode' uses the
maximum power of the appliance.
- Go to Chapter 4 'Use' to switch off
the function and set the temperature.
Check the symbol on the display to
turn off the corresponding function.
- Contact customer service.
39
Advertenties
Hoofdstukken
Inhoudsopgave
