Fronius Primo 3.0-1 Bedieningshandleiding pagina 19
Verberg thumbnails
Zie ook voor Primo 3.0-1:
- Bedieningshandleiding (176 pagina's) ,
- Gebruiksaanwijzing (172 pagina's) ,
- Installatiehandleiding (48 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
NOTE!
If the photovoltaic system has only one inverter, steps 1 and 2 below can be
skipped.
In this case, starting for the first time will commence with step 3.
Connect inverter with Fronius Datamanager 2.0 or Fronius Datamanager Box
1
2.0 to the Fronius Solar Net
When networking several inverters in Fronius Solar Net:
2
Set the Fronius Solar Net master / slave switch on the Fronius Datamanager
2.0 plug-in card correctly
-
One inverter with Fronius Datamanager 2.0 = master
-
All other inverters with Fronius Datamanager 2.0 = slave (the LEDs on
the Fronius Datamanager 2.0 plug-in cards and boxes are not illuminated)
Switch the device to Service mode
3
-
Activate the WLAN Access Point via the Setup menu on the inverter
S t a n d b y
W i F i A c c e s s P o i n t
D A T C O M
U S B
C l o c k
The inverter establishes the WLAN access point. The WLAN access point re-
mains open for 1 hour. The protection switch on the Fronius Datamanager 2.0 can
remain in switch position A due to the activation of the WLAN Access Point.
Installation using the Solar.start
app
Download Fronius Solar.start
4
Run the Fronius Solar.start app
5
Installation using a web browser
Connect the end device to the
4
WLAN access point
SSID = FRONIUS_240.xxxxx (5-8
digits)
-
-
-
(Alternatively, connect the end
device and inverter using an Eth-
ernet cable.)
Enter the following in the
5
browser:
http://datamanager
or
192.168.250.181 (IP address for
WLAN connection)
or
169.254.0.180 (IP address for
LAN connection)
English
Search for a network with the
name "FRONIUS_240.xxxxx"
Establish a connection to this
network
Enter password from the in-
verter display
19
Advertenties
Hoofdstukken
Inhoudsopgave
