Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
34
www.aeg.com
Problem
A
or
instead of numbers on the
Temperature Display.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "Frostmatic" or
"Coolmatic", or after chang-
ing the temperature.
Water flows inside the refrig-
erator.
Possible cause
Temperature sensor prob-
symbol is shown
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "Frostmatic function"
or "Coolmatic function" is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high.
This is normal, no error has
occurred.
Food products prevent the
water to flow into the wa-
ter collector.
Solution
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Frostmatic function"
or "Coolmatic function".
Refer to "Closing the door".
Set a higher temperature. Re-
fer to "Operation".
Set a higher temperature. Re-
fer to "Operation"
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
