Download Inhoudsopgave Inhoud Print deze pagina

Getting To Know Your Appliance; Accessories; Gas Burners; Switching On Manually - Bosch POP6B6B80V Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Getting to know your appliance

en
*Getting to know your
appliance
You can find your appliance and the burner powers in
y o u r a p p l i a n c e
G e t t i n g t o k n o w
the model overview. ~ Page 2

Accessories

The following accessories can be purchased from the
Technical Assistance Service:
--------
Code
HEZ298114 Additional coffee maker support
HEZ298105 Simmer Plate
HEZ298104 Simmer Cap
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
6
Additional support for
espresso makers
Only when using cookware with
a base less than 12 cm in diam-
eter on the smallest burner.
Simmer Plate
This accessory has been
designed to reduce the level of
heat at the lowest power setting.
Place the accessory directly on
the pan support with the cones
facing upwards, never directly
over the burner. Centre the pan
over the accessory.
Simmer Cap
Burner specially designed to
cook at minimum power. In
order to use it, remove the auxil-
iary burner and replace it with
the Simmer Cap burner.
ÄGas burners
There are indications to show which burner each
G a s b u r n e r s
control knob operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.

Switching on manually

Press the chosen burner control knob and turn it
1.
anticlockwise to the required setting.
Use any type of lighter or flame (cigarette lighter,
2.
matches, etc.) and bring it close to the burner.

Switching on automatically

If your hob can be switched on automatically (ignition
sparkers):
Press the chosen burner control knob and turn it
1.
anticlockwise to the maximum power setting.
While the control knob is still pressed down, sparks
are produced on all burners. The flame ignites.
Release the control knob.
2.
Turn the control knob to the required setting.
3.
If it does not come on, turn the control knob to the off
setting and repeat the steps above. This time, press
and hold the control knob for longer (up to 10
seconds).
:
Warning – Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off
the burner and open a nearby window or door. Wait at
least one minute before trying to switch the burner back
on.

Advertenties

Inhoudsopgave
loading

Inhoudsopgave