Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Timer for thermostat function
Using the timer enables you to set two times per 24 hours
for switching on the day temperature and two times per 24
hours for switching on the night temperature.
In order to control the night temperature, it should be set
to at least 5 ºC / 40 oF.
If the night temperature is set to the "- - " position, the
appliance will remain in the standby position.The appliance
will only switch on at the next switch-on time of the day
temperature.
The appliance must be in standby position in order to be
controlled by the timer
Example of switch times
You have set a day temperature and night temperature of,
for example, 20 ºC and 15 ºC.
✹
P1
TIMER = 7 hours; the temperature will go to 20 ºC at
7 am.
P1
TIMER = 9 hours; the temperature will go to 15 ºC at
9 am.
✹
P2
TIMER = 17 hours; the temperature will go to 20 ºC
at 5 pm.
P2
TIMER = 22 hours; the temperature returns to 15 ºC
at 10 pm.
Setting times for the timer
To set the timer, proceed as follows:
• Set the day and night temperature as described above at
section.
• Briefly press the SET button to enter the (P*) TIMER
position.
• Press the SET button until P1
time flashes.
• Set the first switch on time of the day temperature using
the buttons
(large flame) and
• Briefly press the SET button to set the next time of the
cycle, P1
TIMER.
• Successively set the times P2
• Press the OFF button or wait until position (P*) TIMER
appears on the display.
Activating the timer function
Follow the steps below for activating the timer control:
• Place the appliance in the standby (pilot burner) position
using button
(small flame).
• Set the day/night temperature if you have not yet done so.
✹
• Set the timer times P1
TIMER, P1
and P2
TIMER.
• Choose the (P*) TIMER function using the SET button.
✹
TIMER is displayed and the
small flame).
✹
TIMER and P2
TIMER.
✹
TIMER, P2
TIMER
OPERATING INSTRUCTIONS
Replacing the battery
If the battery is almost empty, the display will show "BATT".
To replace the battery, proceed as follows:
• Remove the cover at the back side of the remote control.
• Disconnect the 9V block battery from / connect the 9V
block battery to the connector.
!Caution - Observe the "+" and "-" poles of the batteries
and the connector;
- Use alkaline batteries;
- Batteries are regarded as "small chemical waste"
and may therefore not be disposed with the
household rubbish.
• Place the battery in the holder.
• Replace the cover.
31
Venteo
Advertenties
Hoofdstukken
Inhoudsopgave
