Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Glass window
After placing the wood/pebble set you can plac e the glass
window, as described below.
NB: Avoid damages when removing/placing the glass
window.
Removing the glass window
• Remove the glass window in accordance with the
following instructions (see fig. 17 up to 28):
• Remove the vertical decorative strips on the left and right
of the glass window by pushing the lip at the top of each
strip up, tilting the top of the strip parallel with the glass
window, and then removing the strip.
• Remove the horizontal decorative strip by gripping it with
2 hands in the slot and lifting it out.
• Unscrew the 4 self-tapping screws in the bottom strip
using the socket spanner supplied with the appliance.
• Loosen the 3 self-tapping screws in the fastening strips on
both sides 2 turns.
• NB: Do not remove the self-tapping screws: leave them in
place in the fastening strips.
• Push the 2 top wedges (left and right) down as far as
possible.
• Push the 2 bottom wedges upwards as far as possible.
• Press the two fastening strips outwards with your hands
as far as possible to avoid damage to the sealing cord
when
• removing the glass window.
• Take hold of the top and bottom handgrips and lift the
glass window.
fig. 15
INSTRUCTIONS FOR INSTALLATION
• Pull on the bottom handgrip to tilt the glass window in its
mounting towards you and, at the same time, pull the top
of
• the glass window towards you as far as possible.
• NB: Firmly hold the upper grip. If you let go of the
handgrip then the glass window could fall inwards and
cause severe damage to both the glass and the appliance;
• Make sure that you lift the glass window out of its
mounting as straight as possible to avoid damage to the
paintwork and the sealing cord.
• Gently allow the glass window to drop at an angle until it
can be removed entirely from the mounting.
Placing the glass window
The glass window is fi tted by using the above procedure,
in reverse order.
NB: Avoid/remove fi ngerprints on the pane, since
otherwise they will burn into the surface;
- The self-tapping screws must not be over-tightened,
since otherwise they could break or strip the thread:
tight = tight;
- Replace the fastening strip if the sealing cord has
come loose.
Pay attention to the following when fi tting the glass
window:
• Begin by checking that the two fastening strips are pressed
outwards as far as possible to avoid damage to the sealing
cord, when placing the glass window.
• Fit the glass window.
25
fig. 16
Venteo
Advertenties
Hoofdstukken
Inhoudsopgave
