Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Training area in mm
(for home trainer and user)
Cleaning, Checks and Storage of the exercise pro-
duct:
1. Cleaning
Use only a less wet cloth for cleaning.
Caution: Never use benzene, thinner or other aggressive cleaning
agents for surface cleaning as this damage caused.
The device is only for private home use and for use suitable indoors.
Keep the unit clean and moisture from the device.
2. Storage
Remove the batteries from the computer while intending the unit
for more than 4 weeks not to use. Choose a dry storage in-house
and put some spray oil at front & rear foot tube connection point
and hand grip axle. Cover the bike to protect it from being discolor
by any sunlight and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for
tightness, which were prepared in the assembly. Every 100 operating
hours, you should put some spray oil at front & rear foot tube con-
nection point and hand grip axle.
Free area in mm
(Training area and security area
(rotating 60cm))
Troubleshooting
If you cannot solve the problem with the following information,
please contact the authorized service center.
Problem
Possible Cause
Computer
No Batteries insert
has no value
or batteries empty
at Display if
you press any
key.
Computer is
Sensor impulse
not counting
missing base on
data and do
not well plugged
not switch
connection
on after start
cycling.
Computer is
Sensor impulse
not counting
missing base on
data and do
not correct position
not switch
of sensor.
on after start
cycling.
No pulse
Pulse cable is not
value
plugged in.
No pulse
Pulse sensors not
value
well connected
Resistance
Connection of resi-
don't change
stance not well
21
Solution
Check the position of batte-
ries at battery compartment or
replace batteries.
Check the plug connections at
computer and inside of handle-
bar support.
Überprüfen Sie das Bremsband
auf ordnungsgemäße
Einstellung wie in Montage
Schritt 5 beschrieben.
Check the separately pulse
cable is well connected with
computer.
Screw out the screw for pulse
measurement and check if
plugs are well connected and no
damage at pulse cable.
Check the resistance connec-
tion inside of handlebar support
as manual mention.
Advertenties
Hoofdstukken
Inhoudsopgave
