Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step 5:
Installation of handlebar (5) at handlebar support (4).
1. Place the handlebar (5) against the handlebar support (4)
and adjust so that the hole patterns in the handlebar and the
handlebar support are aligned. Put one spring washer (25) and
washer (33) on each screw (26).
Push the screws (26) through the holes in the support, screw
into the threaded holes of the support (4) and tighten firmly.
2. Push the hand pulse cable (24) thought the holes into the top of
handlebar support (4).
3. Cover the handle bar connection with handlebar cover (27).
Step 6:
Installation of the computer (8) and computer bracket (36).
1. Take the computer (8) that has been supplied out of the pak-
kaging and insert the batteries (Type "AAA"-1.5 V pencells) by
watching for the right polarity on the back of the computer (24).
(Batteries for the computer are not included in this item. Please
buy them at your located market.)
2. Place the computer (8) to support (4) and put the plug of con-
nection cable (18) into the socket from monitor (8) backside and
insert the plugs of pulse (24) too. Push the computer (8) to top
monitor bracket of front post (4) and secure with screws M5x10
(68). (Attention: Ensure that the cable looms are not crunched
or pinched during installation. The screws for computer you find
on backside of computer)
19
Advertenties
Hoofdstukken
Inhoudsopgave
