rlichting
Step 4
k dat we de stekkertjes weer verbinden aan het achterlicht.
Installing the rear carrier onto the bike
The rear carrier includes a separate sachet with small bolts, you'll need them in this step.
1. Remove the bolts at the silver rod that connects the fender to
vast aan de haak aan de zijde van het zadel.
the frame.
2. Bend the legs of the frame outwards.
3. Secure the front side of the rear carrier underneath the saddle
al uitgevouwen is, zie foto.
using the long bolt from the sachet.
en!
4. Secure the legs of the rear carrier at the spot where the silver rod
connects the fender. Use the bolts you have removed in step 1.
e zilveren haak trekken aan de achterzijde
Step 5
Connecting the plug to the lighting
d).
Now that the rear carrier is installed, it's important to re-connect the
erlichting door het frame van de bagagedrager
plugs to the rear light.
1. There's a silver hook in the rear carrier. Using a small piece of tape,
secure the plugs to the hook on the side of the saddle.
het frame komen kan je deze weer verbinden
Tip: Make sure the silver hook is fully extended, see picture.
de verlichting.
It must be pulled all the way through!
ngang je steekt).
2. Now that the plugs are attached, pull at the other end of the silver
hook (the side where you installed the light). This way, the lighting
rische ondersteuning in
wire will be pulled through the frame of the luggage carrier.
3. Now that the plugs are protruding from the other end of the frame,
they can be reconnected to the rear light. Put the plugs in the
lighting. (It doesn't matter which plug goes into which port).
4. Check that the lighting works by switching on the electric assistance and the lighting.
Babboe Mountain Rear Carrier Installation Manual
5