Advertenties
Beschikbare talen
Beschikbare talen
Babboe Mountain Rear Carrier Installation Manual
Congratulations on the purchase of a new rear carrier for your Babboe Mountain!
Below you will find instructions on how to install the rear carrier. To remove the rear carrier, please follow the
steps in reverse order.
You will need the following materials to install the rear carrier:
• Allen key 3
• Tape
• Two screws and two washers (sachet)
Step 1
Remove the rear light
In order to install the rear carrier, you'll first need to remove the rear light.
1. Make sure to unplug the plugs that are attached to the rear light.
Please note: Don't pull the wire, but pull the plug instead. The plug is located at the end of the wire and is
slightly thicker than the wire.
2. Remove the ring lock, otherwise you won't be able to reach
the nuts on the mounting bracket.
3. Remove the lighting and bracket from the bike.
4. Unscrew the bracket, removing it from the lighting.
5. Place the ring lock back.
Step 2
Attaching the rear light to the rear carrier
Now that the rear light has been removed from the bracket, the rear light can be attached to the back of the
rear carrier.
Tip: Use the same nuts that secure the lighting to the bracket.
Step 3
Extending the lighting wire
Since the rear light is now installed onto the rear carrier, it is located further away from the saddle, so it's important
to extend the lighting wire with the plugs. This is easily done by carefully pulling the wire out of the frame.
Remove the saddle and seatpost from the frame, now carefully pull the lighting wire from the frame
(with the saddle/ seatpost in place, the wire could get stuck).
NL | Montagehandleiding Babboe Mountain Baga
Gefeliciteerd met je nieuwe bagagedrager voor jo
Hieronder vind je de instructie voor de montage.
Voor het monteren van de bagagedrager heb je d
•
Inbussleutel 3
•
Steeksleutel 8 & 10
•
Kruiskopschroevendraaier
•
Tape
Stap 1
Verwijderen van het achterlicht
Om de bagagedrager te kunnen plaatsen, dien je e
1. Zorg dat je de stekkertjes die verbonden zitten a
Let op, trek niet aan het draad, maar trek aan de s
herkennen aan een lichte verdikking ten opzichte
2. Verwijder het ringslot, anders kunt je niet bij de
3. Haal de verlichting inclusief beugel van de fiets
4. Schroef de beugel los van de verlichting.
Stap 2
Bevestigen van het achterlicht aan de bag
Nu je het achterlicht verwijderd hebt van de beuge
plaatsen.
Tip: Je kunt hiervoor dezelfde moertjes gebruiken
4
Advertenties
