Overwriting The Master; Overwrite The Master Transmitter For The Lighting System - Becker Centronic VarioControl VC310 Series Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic VarioControl VC310 Series:

Inhoudsopgave

Advertenties

Beschikbare talen

Overwriting the master

To ensure that the new master transmitter is programmed in

the desired radio receiver only, all other receivers which are

connected to the same power supply must be deactivated

from the programming mode. To do so, after switching the

power back on, execute a drive or stop command using the

transmitter for the given receivers.

a) Overwrite the master transmitter by switching on the power

Switch on the power.

► The radio receiver remains in programming mode for 3 minutes.

Now press the programming button of the new master transmitter for 10

seconds.

▻ The receiver confirms.

► The new master transmitter is now programmed and the old master

transmitter deleted.

b) Overwrite the master transmitter using the programming button

Press the "Lighting system" programming button on the radio receiver for

3 seconds.

► The radio receiver remains in programming mode for 3 minutes.

Now press the programming button of the new master transmitter for 10

seconds.

▻ The receiver confirms.

► The new master transmitter is now programmed and the old master

transmitter deleted.

32 - en

Inhoudsopgave

Advertenties

Inhoudsopgave

Centronic variocontrol vc210