Functional Description; Integrated Operating Elements; Control Inputs And External Pick-Ups Note - Becker S60II Gebruiksaanwijzing

Verberg thumbnails

pagina van 28

/ 28
Inhoud
Inhoudsopgave
Bladwijzers

Advertenties

Beschikbare talen

Integrated operating elements

• Door UP

Pressing the UP button (front) opens the door in self-locking. The door stops automatically when the upper end limit is

reached or if a safety function actuates (e.g. emergency stop switch).

If you wish to change to the Up direction while the door is descending, you must press the Stop button ﬁrst of all.

• STOP

The opening or closing door can be stopped immediately in any position by pressing the STOP button (front).

• Door DOWN

Pressing the DOWN button (front) closes the door in deadman's mode. If the "Multicard II" is used with safety edge and

light barrier, closing occurs in self-locking. The door stops automatically when the lower end limit is reached or if a safety

function actuates. If the bottom pneumatic safety-edge rail or light barrier actuates, the door stops and then moves to the

upper ﬁnal position or clears the obstacle, depending on the setting of the Multicard II.

• Emergency stop switch (optional)

When the emergency stop switch is activated, the control voltage is switched off. The "+UB" LED on the motherboard goes

out and the drive is switched off immediately. Further door movement is only possible after releasing the emergency stop

switch.

• Main switch (optional)

The main switch switches the mains feed off at all poles.

• Safety disconnection (optional)

The drive is additionally isolated from the mains with the "Ö-Norm module".

Control inputs and external pick-ups

Note

See also "Functional overview"

• External pick-ups (UP STOP DOWN)

An additional triple pushbutton can be connected, which is identical in func-

tion to the buttons on the front of the control.

• EMERGENCY STOP switch (EMERGENCY STOP)

The S60II control can be supplied with an EMERGENCY STOP switch in the

housing cover, if required.

• Slack cable limit switch (EMERGENCY STOP)

A slack cable limit switch can be connected in series with the EMERGENCY

STOP switch.

• Run-in safety device (STOP-UP)

A break contact in the run-in safety device stops upwards movement.

• 24V DC output voltage

A 24V d.c. voltage, protected by fuse F2 = 200mA, is available, e.g. for sup-

plying a light barrier.

• Bottom pneumatic safety-edge rail (USA)

An electrical (EL) or pneumatic (DW) safety contact rail with 1.2kOhm or 8.2 kOhm can be connected.

• Pulsed input (IMP)

For example, a ceiling pull switch can be connected, which converts the commands into the step switching sequence UP-

STOP-DOWN-STOP-UP ... .

• Light barrier (LS)

If the light barrier is interrupted (break contact), the door stops and ascends again. In conjunction with the automatic re-

closing function, the light barrier resets the closing time to 3 seconds.

If the deadman's insert card is used, the light barrier only produces a stop in the down direction.

• Automatic reclosing feature (WZL)

If the automatic reclosing feature is activated, the open door closes automatically after a preset time.

• 1-channel radio receiver

If a radio receiver (available as an accessory) is mounted, the step switching sequence can be implemented as at the

pulsed input, with the 1-channel hand transmitter.

The Multicard II insert card also provides the following connection options:

• Partial opening

• Optical safety device OSE (FRABA)

For the exact functions and settings, please refer to the instructions for the relevant insert card.