Functional Overview; Installation Instructions - Becker S60II Gebruiksaanwijzing

Verberg thumbnails

pagina van 28

/ 28
Inhoud
Inhoudsopgave
Bladwijzers

Advertenties

Beschikbare talen

Function

Setting mode (Up/Down in deadman's mode)

Self-locking in Up direction

Self-locking in Down direction

External triple pushbutton

Run-in safety device

Slack cable input / Emergency stop

Pulsed input Up/Stop/Down/Stop (IMP)

Automatic closing (AWZ)

Partial opening

Pneumatic switching rail (USA/DW)

Electrical switching rail (USA/EL)

Switching rail change-over: 1.2 kOhm/8.2 kOhm

Optoelectronic switching rail from FRABA (OSE)

Light barrier (LS)

Trafﬁc light/Door status display

Yard light

Warning light (RELAY 1)

LED for power supply (+UB)

LED for ascent (OPEN)

LED for descent (CLOSED)

LED for operating status (Betr)

LED for malfunction (Stör1, Stör2)

LED for switching rail (USA)

LED for pre-limit switch (VES)

LED for redundancy (PIC)

Voltage output (24 V DC / 200 mA)

Function only if a switching rail is used

Installing the control

1. Installing the control

The control device is intended for use indoors and is to be installed at the desired operating height. The housing cover with the

triple pushbuttons can be removed during installation by means of the plug-in connection (connector is retained and engages

audibly when ﬁtted).

2. Installing the supply point

Mount a CEE 16A/6h socket beneath the control (protect with 3x10A 3-pole rotary current overload circuit breaker), or con-

nect the control via a permanently laid installation cable. During commissioning, the cover can be screwed on with just two

screws so that it is laterally offset (open housing facilitates operation of buttons).

Attention

During all wiring work, the system must be disconnected from the power by removing the CEE plug or

switching off the main switch. Observe the applicable VDE guidelines during installation.

3. Motor/control connection

The drive cable (12-wire) must be connected to the appropriate terminals in accordance with the connection plan (not re-

quired if connection has already been carried out by Becker). The terminal designations correspond to the numbers of the

drive cable wires (without wire 4 and 10).

The ﬁtted CEE plug can be used as the main switch. If the control is connected without the CEE plug (e.g. permanent connec-

tion), a main switch must be connected into the mains feed.

4. Installing a control card

The S60II door control can be retroﬁtted or upgraded by changing the control card. The following control cards are currently

available:

• Deadman's control card

• Multicard II control card

For the card functions, please refer to the "Functional overview" or the relevant operating instructions. Disconnect the control

from the power before changing the card. Make sure that the contact pins ﬁt snugly.

Attention

Relevant precautions must be taken when handling static sensitive components