Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Assembly Instructions:
Remove all the separate parts from the packaging, lay them on the
floor and check that all are there on the basis of the instructions
for assembly and use.
1. Vibrationmachine
2. Remote control
3. 2x elastic ropes with carbine hooks
4. AC connection cable
Fold out the holder for elastic ropes located in front of Vibro 2 an
connect the elastic ropes with safety hooks. Ensure before each
training, that the elastic ropes are secure. Don't bend the elastic
ropes more than 1,50m. During using the elastic ropes it is necessary
to fix the Vibro 2 with body weight to keep floor contact.
Take the remote control out of the packaging and insert the batter-
ies (Type "AAA"-1.5 V pencells) on the back side into the battery
compartment by watching for the right polarity. (Batteries for the
remote control are not included in this item. Please buy them at
your located market.)
Mainconnection:
A) Mainswitch = Switches the machine On and Off
B) Fuse = Fuse (5x20mm) T5A/250Volt protects for overload
C) AC connector = Socket for AC cable
How To Operate
1. Plug in the AC connection cable into the AC socket of Vibro 2
and then insert to a suitable and save installed jack of wall power
(230V~50Hz). Press ON/OFF main switch to get ON position.
2. Press the „
„-key and the product will start with speed level 1
for 15 Minutes.
3. Press the Speed +key , the intensities will be higher, till to the
highest level 60 .
4. Press the Speed -key, the intensities will be lower, till to the
lowest level 1.
5. Press the „
„ -key again to finish the workout.
6. Turn off the main switch ON/OFF if the product is not in use.
When the product is not in use, it should be unplugged.
13
Advertenties
Hoofdstukken
Inhoudsopgave
