Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step 7:
Installation of butterfly arm left and right (9L+9R), hand grip
(21) and arm foam (42).
1. Put the left and right butterfly arms (9L/R) into the Butterfly arm
support (6) and secure with bolt M10x90 (78), washer 10//20 (67) and
nylon nut M10 (64). Insert the locking pins (23) to secure butterfly
arm position and cover the nuts (64) with screw cap (74).
2. Slide the arm foams (42) onto the butterfly arms left and right
(9L+9R) (perhaps by help of a little bit soap water) and tighten hand
grips (21) at butterfly arms (9L/R) with screws M8x25 (59), screws
M8x16 (58) and curved washer 8//25 (72).
Note:
For bench press exercising secure the butterfly arms left and right
(9L+9R) with locking pins (23) at butterfly arm support (6) and screw
loosely and fold back the handgrip nut (29). For butterfly exercising
secure position of butterfly arm support (6) with hand grip nut (29)
und take out the locking pins (23) from butterfly arms (9L+9R).If no
use of locking pins you can storage at main frame (34) as figure
A shows.
Step 8:
Installation of cable 1 for butterfly (38) with pulleys (19).
(Note: The assembling of cables needs a simultaneously
assembling of pulleys. So please insert the cable each time
before you assemble a pulley and don't tighten the screws for
pulleys too much. The pulley should turn easy after assembly.)
1. Screw one end of the cable 1 (38) at the holder of the butterfly
arm left (9L) with bolt M10x35 (51), washer 10//20 (67) and nylon
nut M10 (64).
2. Attach one pulley (19) with cable 1 (38) and pulley covers (20)
into 1st pulley holder (27) and secure with hex bolt M10x50 (50),
washer 10//20 (67) and nylon nut M10 (64).
3. Attach one pulley (19) with cable 1 (38) and pulley covers (20) into
twisted pulley holder (26) and secure with hex bolt M10x50 (50),
washer 10//20 (67) and nylon nut M10 (64).
4. Attach one pulley (19) with cable 1 (38) and pulley covers (20)
into 2nd pulley holder (27) and secure with Hex bolt M10x50 (50),
washer 10//20 (67) and nylon nut M10 (64).
5. Screw the other end of the cable 1 (38) at the holder of the
butterfly arm right (9R) with bolt M10x35 (51), washer 10//20 (67)
and nylon nut M10 (64).
6. Cover all screw heads of screws (50+51) and nuts (64) with
corresponding screw caps (74).
23
Advertenties
Hoofdstukken
Inhoudsopgave
