Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step 3:
Installation of top frame (11) and end tube (44).
1. Insert the end tube (44) in right direction on top of the sliding
tubes (5) and screw tightly with hex bolt M10x25 (52) and curved
washer 10//25 (71).
2. Place the top frame (11) onto the main frame (34) and screw
it loosely together by using carriage bolt M10x65 (53), washer
10//25 (71) and nylon nut M10 (64). Additional secure this point
loosely with screws M8x25 (57), washers 8//16 (68), bushing (70)
and nylon nut M8 (65). Then put the holder of top frame (11) and
end tube (44) together and screw tightly with screws M10x65 (49)
curved washers 10//25 (71) and nylon nuts M10 (64). Also tighten
now the screws (53+57).
3. Push the adjustment screws (33) (with top cover bracket (82))
through the holes of end tube (44) and secure on top with curved
washer 8//25 (72) and butterfly nut (62).
4. Cover all screw heads of screws (49+52+57) and nuts (64+65)
with corresponding screw caps (74+75+76).
Step 4:
Installation of leg curl frame (7) and seat (14).
1. There are 3 holes at the support tube (34). Please use the bottom
and middle hole for balance frame (2) and the middle and upper hole
for the leg curler frame (7). To fix this, use the appropriate screws
(48+49), washers (71) and nuts (64).
2. Adjust the seat (14) on curl frame (7) so that the threaded holes in
the rear of seat (14) are align with the seat support (79) and screw it
tightly by using washers 6//16 (69) and screws M6x15 (60).
3. Cover all screw heads of screws (48) and nuts (64) with screw
caps (74).
21
Advertenties
Hoofdstukken
Inhoudsopgave
