Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
32
www.aeg.com
• The level of rinse aid according to the
required dosage.
• The activation or the deactivation of
the option AutoOpen.
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when the programme indicator
is on and the display shows the
programme duration.
When you activate the appliance, usually
it is in programme selection mode.
However, if this does not happen, you
can set the programme selection mode
in the following way:
Water hardness
German de-
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
If you use multi-tablets containing salt
and the hardness of your water is lower
than 21dH, you can set the lowest water
softener level. It deactivates the salt refill
indicator.
If you use standard detergent or multi-
tablets without salt, set the proper
water hardness level to keep the salt
refill indicator active.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
Press and hold simultaneously Delay and
Option until the appliance is in
programme selection mode.
6.2 The water softener
The water softener removes minerals
from the water supply, which would have
a detrimental effect on the washing
results and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. It is important to set the
right level of the water softener to assure
good washing results.
mmol/l
Clarke de-
grees
8.4 - 9.0
58 - 63
7.6 - 8.3
53 - 57
6.5 - 7.5
46 - 52
5.1 - 6.4
36 - 45
4.0 - 5.0
28 - 35
3.3 - 3.9
23 - 27
2.6 - 3.2
18 - 22
1.9 - 2.5
13 - 17
0.7 - 1.8
5 - 12
<0.7
< 5
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
Water softener lev-
el
10
9
8
7
6
1)
5
4
3
2
2)
1
,
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
