Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Switching on for the first time
Ensure that the boiler is filled with water!
Boiler
1. Operate the mixer tap and flush with warm
water for 1 minute (fig. 1).
2. Activate the electronic knob and select the
boiling water (red LED) (fig. 2). Press the
electronic knob 3 times. Repeat this step
twice to ensure the boiler is flushed and full of
water. The system will be flushed. It is normal
that at the beginning of the flushing mode air
comes out. When there is a smooth laminar
flow out of the tap, the system is properly
flushed.
3. Switch on the boiler (fig. 3).
1
2
Tap operation
Operation of mixer lever
Select hot water (fig. 4).
4
Select cold water (fig. 5).
5
4. Inspect the installation for leaks after
commissioning.
Water reaches boiling temperature after
approximately 15 minutes.
Warning: If, during heating, no expansion
water has escaped via safety group (black
pressure valve) after 10 minutes:
Switch off the power supply immediately and
turn on the boiling water tap to relieve the water
pressure.
The boiler is heated up when the ON/
STANDBY button has a steady red light.
5. To clean the tank activate the boiling water
tap until cold water runs out.
3
Turn on mixer tap (fig. 6).
6
Operation of electronic knob
Activate tap: Press briefly 1x (fig. 7).
7
29
EN
Advertenties
Hoofdstukken
Inhoudsopgave
