Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Operation
Operation of boiler
Briefly pressing the ON/STANDBY button
switches between the boiler modes ON and
STANDBY.
ON:
– The LED is continousily red.
OFF:
– The LED is off.
When the boiler has been switched of for a
week, we recommend that the following
procedure is observed before use:
Switch on boiler. Wait until the boiler water is
up to temperature.
Open the boiling water tap and flush the
boiling water line until cold water comes out
of the tap.
Caution: Ensure that the water does not
atomise during flushing.
Heat the boiler water again.
Decommissioning boiler
1. Remove the plug of the boiler from the wall
plug socket.
2. Start the water flow on the electronic knob.
3. Wait until cold water runs out.
4. Stop the water flow on the electronic knob.
5. Close the stop valve.
6. Start the water flow on the electronic knob.
7. Wait until water no longer runs out.
8. Stop the water flow on the electronic knob.
9. Disconnect the hoses from the boiler.
10.Remove the boiler.
11. Allow the water from the hoses and the boiler
to drain into the sink.
Taking boiler out of service
If you do not expect to need any boiling water
for a prolonged period, such as during holidays,
you can switch off the boiler (temporarily):
Use the boiler STANDBY mode, or remove the
plug from the wall plug socket to prevent
heating of the boiler.
28
Advertenties
Hoofdstukken
Inhoudsopgave
