Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
the (hot) party-tent heater to a socket.
Your party-tent heater is now ready for use.
Operating
Insert the plug into the socket. Check beforehand whether this
socket meets the requirements indicated on the party-tent
heater's specification plate , i.e. 220-240V / 50Hz.
Partytent 1000:
Pull on the pull-cord once. The lamp will come on and the party-
tent heater will emit 1000W of heat.
Pulling on the pull-cord again will switch the party-tent heater off.
These settings will be repeated if you continue to pull the cord.
Partytent 1500:
Pull on the pull-cord once. The smaller, lower lamp will go on and
the corresponding indicator light will come on. The party-tent
heater will emit 600W of heat.
Pulling on the cord again will switch on the larger, higher lamp
(900W). The corresponding indicator light will come on.
Pulling on the pull-cord for a third time will switch on both lamps.
Both indicator lights will now come on and the heater will emit
1500W of heat.
Pulling on the pull-cord for a fourth time will switch the party-tent
heater off. The lights will go out.
These four settings will be repeated if you continue to pull the
cord.
The following applies to both types:
The party-tent heater is not equipped with a thermostat and will
continue to emit heat for as long as it is switched on. Never leave
a functioning party-tent heater unsupervised!
Remove the plug from the socket once the lights have gone off if
you wish to turn the device off.
21
Advertenties
Inhoudsopgave
