Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1.
ON/OFF button
2.
Timer button
3.
High/low output button
4.
Temperature & duration higher
5.
Temperature & duration lower
6.
Symbol high/low output active
7.
Output set at 1000W
8.
Output set at 2000W
Set-up and Operation
• Set the main switch (back) to I (on). You can now operate the heater with buttons 1 to 5
on the control panel or the remote control.
• Press once on the on/off button (1); the heater will start to work and the LCD screen will
light up.
• By pressing once or twice on the high/low output button, you can select the low (1000W)
or high (2000W) setting, respectively. Symbol 7 or 8 indicates this. If the room
temperature is under the set temperature, the heater will heat at 1000 or 2000W. As the
heater is heating, symbol 6 will blink: half for 1000W, full for 2000W.
• Set the desired temperature by pressing buttons 4 (higher) or 5 (lower). Symbol 12 will
blink for a few seconds to indicate the set temperature; symbol 9 and 10 will blink too.
After a few seconds, the 9 will go out and the display (12) will once again show the
ambient temperature. The temperature can be set to between 15 and 45°C. If the set
temperature is lower than the ambient temperature, the heater will stop heating and just
ventilate. When the ambient temperature drops below the set temperature, the heater
will once again blow out hot air.
• In order to set a specific time with the timer, press the timer buttons (2) when the heater
is on. Symbol 15 (usually set to 00) will begin to blink and you
can now use the + and - buttons to set and/or adjust the
functional period (from 0 to 24 hours). Every time you press
the button the set period is increased or decreased by one
hour. By pressing the timber button again, you confirm the
setting and it will stop blinking. The heater will now function
for the set period and then automatically switch off.
• Pressing on the on/off button will switch the heater off. Press
the main switch again (O) and remove the plug from the
socket.
Safety features
Tipping safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the appliance if it
inadvertently falls over. When the heater is returned to its upright position, it will resume
9.
Symbol 'temperature is set'
(SET)
10. Symbol 'temperature' (TEMP)
11. Symbol '°C'
12. Display of set and room
temperature
13. Symbol 'timer active' (TIMER)
14. Symbol 'timer on display' (H)
15. Set functional duration
Advertenties
Inhoudsopgave
