Inhoudsopgave
Advertenties
7.3
Switching On-off (Fig. 1)
Connect the plug to the power supply.
▪
Switch the power tool on: push the ON/OFF switch button (1) forwards onto the "I"
position.
▪
Switch the power tool off: pull the ON/OFF switch button backwards to the "O" position.
WARNING: Never use the machine for sanding magnesium work piece.
7.4
Replace and install the sanding base and extension plates
NOTE: There are three sanding bases (round / triangular / rectangular) and
two extension plates (finger-type plate and cylindrical-type plate).
Depending on the sanding activity, choose the most suitable one.
Important: Prior to any assembly and adjustment always unplug the tool.
7.4.1
Remove the sanding base (round / triangular / rectangular) (Fig. 2)
▪
Open the clamping lever (A) on the sanding base.
▪
Push the sanding base release button (B)
▪
While holding the sanding base release button down (B), pull the sanding base off in a
downward direction.
▪
Clean the sanding base and the machine.
7.4.2
Mounting a sanding base (round / triangular rectangular) (Fig. 3)
▪
Open the clamping lever (A) on the sanding base.
▪
Look at the arrow on the rectangular sanding base. Make sure this arrow is always on the
front of the device.
▪
There are 4 pins (1 oval pin, 1 round pin and 2 round pins with a notch) on a round
turnable on the bottom of the device. Make sure these are aligned with the corresponding
holes in the sanding base (C, circled on the description picture).
▪
While the 4 pins on the round turnable are aligned with the corresponding holes, also align
the other 4 pins on the outside of the sanding base (D, framed on the description picture)
and press the sanding base onto the machine.
▪
Close and lock the clamping lever (A) on the sanding base.
7.4.3
Mounting an extension plate (finger-type / cylindrical-type plate) (Fig. 4)
NOTE: You can only mount the extension plates in combination with the
triangular sanding base. Not possible to mount the extension plates on the
round and rectangular plate.
▪
Make sure the triangular sanding base is mounted
▪
Open the clamping lever (E) on the tip of the triangular sanding base.
▪
Lift out and remove the tip (F) of the triangular sanding base
▪
Mount the finger-type (10) or cylindrical-type plate (11)
▪
Close and lock the clamping lever (E) on the tip of the triangular sanding base.
Copyright © 2024 VARO
POWXBOX026
P a g e
| 6
EN
www.varo.com
Advertenties
Hoofdstukken
Inhoudsopgave
