Inhoudsopgave
Advertenties
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
5.5
Service
▪
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 ADDITIONAL SAFETY-HINTS FOR SANDERS
▪
Always wear safety-goggles and a dust-mask during your work with the finishing-sander.
▪
Always secure the work piece by clamps or else to avoid slipping away.
▪
Always keep the holes in the base plate clean from dust.
▪
Always connect a vacuum cleaner to the attached adaptor during your work.
▪
Take special care when sanding lead based paint:
− All persons entering the work area must wear a mask specially designed for protection
against lead paint dust and fumes.
− Children and pregnant women must not enter the work area.
− Do not eat, drink or smoke in the work area.
▪
Do not leave the tool running. Operate the tool only when hand-held.
▪
Ventilate your work area adequately when you perform sanding operations.
▪
Be sure that there are no cracks or breakage on the pad before use. Cracks or breakage
may cause a personal injury.
7 OPERATING INSTRUCTIONS
Before attempting to use your sander be sure to familiarize yourself with all its operating
features and safety requirements.
Warning! The sander should always be disconnected from the power
supply when assembling parts, marking adjustments, cleaning or when the
tool is not in use. Disconnecting the tool will prevent accidental starting
that could cause serious injury.
WARNING: Do not sand plaster surfaces, (WARNING: In this case your
guarantee becomes void). This may clog the motor (brushes, ball bearings,
..).
7.1
Sanding
▪
Hold the sander in front and away from you, keeping it clear of the work piece.
▪
Start the sander
▪
Let the motor build up to speed then gradually lower it on to the work with a slight forward
movement .
▪
Move the sander slowly over the work piece using forward and back or side to side
strokes.
▪
Work with low and even pressure and even forward pressure. This protects the appliance
and the sanding sheet.
▪
Upon completion of the sanding operation remove the sander from the work piece before
turning if off.
▪
Wait until the power tool has stopped before placing it down.
7.2
Set up the speed level
▪
Use the speed adjusting dial (2) to select the desired speed level (from 1 to 6).
1 is the lowest speed and 6 is the highest speed.
Copyright © 2024 VARO
POWXBOX026
P a g e
| 5
EN
www.varo.com
Advertenties
Hoofdstukken
Inhoudsopgave
