Inhoudsopgave
Advertenties
Maintenance and Malfunction Treatment
1) The surface of the treadmill should be kept clean, pull out the power line
before cleaning. You can clean the running belt and the surface of the treadmill
with a soft and wet cloth.
2) The running belt is adjusted at factory; it may runs defectively after
transportation and use. Turn off the treadmill before adjusting, pull the belt in
the center, and then adjust the left and right bolts in rear roller with hex
spanner (See figure ) it is better to adjust 1/2 circle once. Then turn on the
switch, check if the belt
10 runs defectively when the running speed is 4~5 km/h.
3) After using over 100hours or the lubricant between the running board and
the running belt is used up, please lubricate the running board and adjust the
running belt well.
4) After a long time of running, the belt may be longer and stuck. You should
turn the left and right adjustor bolt in rear roller clockwise at same position till the runs smoothly and freely.
Warning:
1) The safety level of the equipment can be maintained only if it is examined regularly for damage and wear, e.g. pins,
connection points.
2) Please replace defective components immediately and/or keep the equipment out of use until repair.
CODE
E1
Message failure between computer
and bottom control board
E2
Burst clash
E3
Speed sensor fault
E5
Current overload protecting
REASON
SOLUTION
4. Check the computer and bottom control board wire
connect well;
5. Check if IC on bottom control board is loosen, reset
the IC
6. Power on bottom control board has some problem,
change the bottom control board
3． Check the power is right, if not, use correct power to
test;
4． Check if the bottom control was burnt out, change a
good one; reconnect the motor wire.
2. control board defective, change a new control board.
4. Too much friction in running belt,add some silicon oil.
Advertenties
Inhoudsopgave
