. Installing the indoor unit
1
2
4
5
Fig. -1
PKFY-P·VHM-E
H
C
E
B
A
C
E
D
Fig. -
All manuals and user guides at all-guides.com
.1. Check the indoor unit accessories (Fig. -1)
3
The indoor unit should be supplied with the following accessories.
.. Installing the wall mounting fixture
..1. Setting the wall mounting fixture and piping positions
► Using the wall mounting fixture, determine the unit's installation position
G
Before drilling a hole in the wall, you must consult the building contractor.
PKFY-P·VHM-E (Fig. -)
F
(mm)
... Drilling the piping hole (Fig. -)
D
B
► Use a core drill to make a hole of 75-80 mm diameter in the wall in the
► The hole should incline so that the outside opening is lower than the
► Insert a sleeve (with a 75 mm diameter and purchased locally) through the
Note:
100
A
The purpose of the hole's inclination is to promote drain flow.
K
I
J
Fig. -
A Sleeve
B Hole
C (Indoors)
D Wall
E (Outdoors)
PART NUMBER
ACCESSORY
Mount board
1
Tapping screw 4 × 35
2
Felt tape
3
Band
4
Block of cushion
5
and the locations of the piping holes to be drilled.
Warning:
A Mount board 1
B Indoor unit
C Bottom left rear pipe hole (ø65)
D Bottom right rear pipe hole (ø65)
E Knockout hole for left rear hole (70 × 310)
F Bolt hole (4-ø9 hole)
G Center measurement hole (ø2.5 hole)
H Tapping hole (77-ø5.1 hole)
I Hole centre
J Align the scale with the line.
K Insert scale.
piping direction, at the position shown in the diagram to the left.
inside opening.
hole.
QUANTITY
LOCATION OF SETTING
32, 40, 50
1
12
3
Fix at the back of the unit
3
1